Ip Unicast Cache Aging; Ip Unicast Cache Aging Timeout - Avaya P330 Reference Manual

source port
destination port
established
Example:
Router-N(configure)# ip simulate 100 192.67.85.12
193.76.54.25

ip unicast cache aging

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
This command applies to the P333R and P333R-LB only.
Use the ip unicast cache aging command to enable aging of unicast cache
entries.
Use the no ip unicast cache aging command to disable aging.
The default is enabled.
The syntax for this command is:
[no] ip unicast route aging
Example:
Router-N(configure)# ip unicast cache aging
Done!

ip unicast cache aging timeout

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
This command applies to the P333R and P333R-LB only.
Use the ip unicast cache aging timeout command to set the time (in
seconds) after which an unused record is deleted.
Avaya P330 Reference Guide
Chapter 3 Avaya P330 Layer 3 CLI Commands
integer (1 - 65535)
integer (1 - 65535)
value of TCP established bit
187