Chapter 3 Avaya P330 Layer 3 Cli Commands; How The Layer 3 Cli Is Organized; Router Configuration Contexts; Shortcuts To Commands By Context - Avaya P330 Reference Manual

Chapter 3
Avaya P330 Layer 3 CLI Commands
This chapter provides all the Layer 3 CLI (Command Line Interface) commands,
parameters, and their default values.

How the Layer 3 CLI is Organized

The commands that make up the Layer 3 CLI are organized alphabetically and
according to context.

Router Configuration Contexts

You can either use the general Layer 3 commands available from the
Router(configure)# prompt or you can enter one of two router configuration
context modes:
Router interface context
Allows you to define parameters individually for each interface. To enter this
context, type interface <interface_name>
The prompt changes to Router-N(config-if:<interface_name>)#
Router protocol context
Allows you to define parameters for a specific routing protocol (RIP, OSPF, and
SRRP). To enter this context, type router <protocol_name>
The prompt changes to Router-N(config router:<protocol_name>)#
To exit these context modes, type the command exit.

Shortcuts to Commands by Context

Command descriptions are organized into the following contexts:
General Commands
Interface context Commands
Router RIP context Commands
Router OSPF context Commands
Router SRRP context Commands
Avaya P330 Reference Guide
Page 164
Page 236
Page 253
Page 255
Page 258
163