Set Interface Ppp; Set Interface Ppp Enable/Enable-Always/Disable/Off/Reset - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands
Example:
To configure the inband interface on VLAN 1, IP address 1.1.1.1 and netmask
255.255.255.24:
P330-N# set interface inband 1 1.1.1.1 255.255.255.24
Interface inband IP address set.
You must reset the device in order for the change to take
effect.

set interface ppp

User level: privileged, supervisor.
Use the set interface ppp command to configure the Master agent PPP
interface IP parameters, exit modem mode, disconnect the PPP session, or reset the
connected modem.
You must configure an IP address and net-mask for the P330 before you can
establish a PPP connection. The IP address is a dummy address that is shared
between two peers, and must be taken from a subnet that is different from the
agent's inband IP subnet.
The syntax for this command is:
set interface ppp <ip_addr> <net-mask>
ip_addr
net-mask
Example:
P330-N# set interface ppp 149.49.34.125 24
Interface ppp ip address set

set interface ppp enable/enable-always/disable/off/reset

User level: privileged, supervisor.
Use the set interface ppp command to enter modem mode, enter terminal
mode, disconnect the PPP session or to reset the connected modem.
The syntax for this command is:
52
IP address used by the P330 Supervisor Module to connect via
its PPP interface
Subnet mask used by the P330 Supervisor Module to connect
via its PPP interface
Avaya P330 Reference Guide