Set Mac-Aging-Time; Set Port Auto-Negotiation-Flowcontrol-Advertisement - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands
P330-N# set mac-aging disable
mac aging is disabled.

set mac-aging-time

User level: privileged, supervisor.
This command is available on the P330-ML switches only.
Use the set mac-aging-time command to set the MAC aging time in minutes.
This is the time after which unused MAC addresses in the MAC table are erased.
The syntax for this command is:
Set mac-aging-time <aging-time>
aging-
time
Example:
P330-N# set mac-aging-time 5
mac aging time is set to 5 minutes.
The entered value is the aging-time lower bound. The actual aging-time might
be up to three minutes longer.

set port auto-negotiation-flowcontrol-advertisement

User level: privileged, supervisor.
Use the set port auto-negotiation-flowcontrol-advertisement
command to set the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <module>/
<port> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
module
port
no-flowcontrol
58
Aging time in minutes (1-3600; default =5).
Number of the module.
Number of the port on the module. If you do not specify a
number, all the ports on the module are set. Alternatively,
you can specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
The port will advertise no pause capabilities.
Avaya P330 Reference Guide