Set Port Dot1X Tx-Period; Set Port Duplex - Avaya P330 Reference Manual

set port dot1x tx-period

User level: supervisor
Use the set port dot1x tx-period command to set the time interval between
attempts to access the Authenticated Station.
The syntax for this command is:
set port dot1x tx-period <module/port> <seconds>
module/
port
seconds
Example:
P330-1(super)# set port dot1x quiet-period 1/2 5000

set port duplex

User level: privileged, supervisor.
Use the set port duplex command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports. You can configure Ethernet and Fast
Ethernet interfaces to either full duplex or half duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation. An error message is generated if you attempt to set the transmission
type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.
P332G-ML and P332GT-ML ports and P334T-ML ports 51, 52 (Gigabit SFP
ports) work in Full duplex mode only. An error message is generated if you
attempt to change these ports to half-duplex.
The syntax for this command is:
set port duplex <module>/<port> {full|half}
module
port
full
half
Avaya P330 Reference Guide
Module and port number (or range of ports)
Number of seconds — 0-65535
Number of the switch in the stack. If you do not specify a
number, the ports on all the switches are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
Set full-duplex transmission
Set half-duplex transmission
Chapter 2 Avaya P330 Layer 2 CLI Commands
65