Cpu And Memory Utilization; Show Commands; Mlt Or Dmlt - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting tools

CPU and memory utilization

The CPU utilization feature provides data for CPU and memory utilization. You can view CPU
utilization information for the past 10 seconds (s), 1 minute (min), 10 min, 1 hour (hr), 24 hr, or since
system startup. The switch displays CPU utilization as a percentage. With CPU utilization
information you can see how the CPU was used during a specific time interval.
The memory utilization feature provides information about the percentage of the dynamic memory
currently used by the system. The switch displays memory utilization in terms of the lowest
percentage of dynamic memory available since system startup.
For more information about CPU and memory utilization, see Configuring System Monitoring on
Avaya Virtual Services Platform 7000 Series, NN47202–505.

Show commands

You can use ACLI show commands to display valuable feature configuration information. The show
tech command displays detailed information incorporated from several individual show commands,
including but not limited to the following:
• show mac-address-table
• show lacp aggr
• show lacp port
• show ipv address
• show ipv interface
• show system verbose
• show ipv6
• show mlt
• show vlan
• show spanning-tree
• show interface
• show log

MLT or DMLT

Enable a MultiLink Trunk (MLT) or a Distributed MultiLink Trunking (DMLT) to help you detect
connectivity issues. You can use the following ACLI commands to manage an MLT or DMLT:
• Use the show mlt command to verify the status of an MLT or DMLT.
Troubleshooting Avaya VSP 7000 Series
22
Comments on this document? infodev@avaya.com
July 2015