Ip Max-Route-Entries; Ip Netmask-Format - Avaya P330 Reference Manual

Chapter 3 Avaya P330 Layer 3 CLI Commands

ip max-route-entries

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
The ip max-route-entries command exists for compatibility with Avaya™
P550. There is no limitation on the size of the routing table, except for the amount of
available memory.
Use the no ip max-route-entries command to remove the limitation.
The syntax for this command is:
[no] ip max-route-entries <value>
value
Example:
Router-N(configure)# ip max-route-entries 4000

ip netmask-format

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip netmask-format command to specify the format of netmasks in the
show command output.
Use the no ip netmask-format command to restores the default format which is
a dotted decimal.
The syntax for this command is:
[no] ip netmask-format <mask-format>
The possible mask formats are:
bitcount
decimal
184
Number of entries
Addresses are followed by a slash and the total number of bits
in the netmask. For example 17
The network masks are in dotted decimal notation. For
example, 255.255.255.0.
Avaya P330 Reference Guide