Rmon2 Host; Rmon2 Matrix - Avaya P330 Reference Manual

Example:
Router-N> reset
This command will force a switch-over to the master module
and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.

rmon2 host

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
This command applies to the P333R only.
Use the rmon2 host command to enable the RMON2 host application.
Use the no rmon2 host command to disable the application.
The syntax for this command is:
[no] rmon2 host
Example:
Router-N(configure)# rmon2 host
Done!

rmon2 matrix

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
This command applies to the P333R only.
Use the rmon2 matrix command to enable the RMON2 Matrix application.
Use the no rmon2 matrix command to disable the application.
The syntax for this command is:
[no] rmon2 matrix
Avaya P330 Reference Guide
Chapter 3 Avaya P330 Layer 3 CLI Commands
191