Set Qos Dscp-Name; Set Qos Policy-Source - Avaya P330 Reference Manual

Example:
Router-N(configure)# set qos dcsp-cos-map 9-16 fwd3

set qos dscp-name

User level: privileged, supervisor.
This command applies to the P333R only.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-name command to configure the DSCP entry name.
The syntax for this command is:
set qos dscp-name <dscp> <name>
dscp1
name
Example:
Router-N(configure)# set qos dscp-name 10 special
If you wish to enter a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".

set qos policy-source

User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Avaya P330 Reference Guide
Chapter 3 Avaya P330 Layer 3 CLI Commands
dscp entry (0-63)
entry name
199