Set Queuing Scheme; Set Radius Authentication Enable/Disable - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands

set queuing scheme

User level: privileged, supervisor.
This command is applicable to P330-ML switches only.
Use the set queuing scheme command to set the queuing scheme to either strict
or weighted round robin and to set the weights.
If this command is to be implemented on a P330-ML switch other than the stack
master, a session should be opened to the relevant switch.
The syntax for this command is:
set queuing scheme {strict | wrr} [ratio]
stric/twr
ratio
Example:
P330-N# set queuing scheme strict
Queuing scheme is set to strict
P330-N# set queuing scheme wrr 8
Queuing scheme is set to wrr 8

set radius authentication enable/disable

User level: supervisor
Enables or disables RADIUS authentication for the P330 switch.
The syntax for this command is:
set radius authentication {enable|disable}
enable
disable
Example:
P330-1(super)# set radius authentication enable
84
Sets queuing scheme to strict or weighted round robin
Ratio between high and low priority queues
Enable RADIUS authentication
Disable RADIUS authentication (default)
Avaya P330 Reference Guide