Using The Show Debug Generic Command - Avaya 8800 Troubleshooting Manual

Important:
In some cases, these debug commands can take a long time to display the information on the
screen. To avoid displaying messages on the console screen, enter config log screen
off.
You can only enter one command for any group at a given point of time.

Using the show debug generic command

Use the show debug generic [verbose] command for debugging purposes only.
The following table describes the commands displayed by the show debug generic
command. The table also lists the recommended number of times to execute the command
(once or twice) in order to obtain best results for meaningful analysis of the specified data.
Executing the command twice allows for an analysis of data at two different time periods.
Table 10: show debug generic commands
Command
readrtc
sysCliShowPerf
cppShowStats
cppSocketStats
Show
spyReport
sopShowStats
tcpstatShow
udpstatShow
ipstatShow
mbufShow
inetstatShow
ifShow
Troubleshooting
Definition
Displays the local and hardware time.
Displays system performance parameters like CPU/SF/
Buffer utilizations and DRAM info.
Displays statistics and details of packets sent to the
CPU.
Displays cpp socket statistics like fd, sockerror etc.
Displays a list of tasks running, their task priority, and
how many ticks of the CPU they used in the last polling
cycle.
Displays statistics on packets sent to the System
OctaPID.
Displays statistics for all the TCP packets.
Displays statistics for all the UDP packets.
Displays statistics for all the IP packets.
Displays the number of memory buffers available to the
system.
Displays all internet protocol (TCP/UDP) socket
connections
Displays network interfaces info.
Using the shell debug wrapper commands
For best
results
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
execute twice
July 2013 125