Show Snmp - Avaya P330 Reference Manual

show snmp

User level: user, privileged, supervisor
Use the show snmp command to display SNMP information.
The syntax for this command is:
show snmp
Example:
P330-N>show snmp
Authentication trap disabled
Community-Access
----------------
read-only
read-write
trap
Trap-Rec-Address
----------------
192.138.40.59
Avaya P330 Reference Guide
Chapter 2
Community-String
----------------
public
public
public
Status Traps Configured
-------- ----------------
Enabled config
fault
trafic_threshold
module_De-Enrollment
module_Enrollment
delete_SW_redundancy_entry
create_SW_redundancy_entry
temperature_warning
general_threshold
cam_change
duplicate_ip
ip_vlan_violation
link_aggregation_connection_fault
link_aggregation_connection_return
link_aggregation_partial_fault
link_aggregation_partial_return
link_aggregation_auto_neg_fault
link_aggregation_auto_neg_fault_return
delete_lag
create_new_lag
active_policy_list_change
policy_access_control_violation
PSU_module_fault
PSU_module_fault_return
fans_module_fault
fans_module_fault_return
Avaya P330 Layer 2 CLI Commands
149