Show Arp-Tx-Interval; Show Autopartition - Avaya P330 Reference Manual
Stackable switch
Hide thumbs
Also See for P330:
- User manual (89 pages) ,
- User manual (214 pages) ,
- User manual (281 pages)
Table of Contents
Advertisement
Chapter 2
Avaya P330 Layer 2 CLI Commands
show arp-tx-interval
User level: user, privileged, supervisor
Use the show arp-tx-interval command to display the keep-alive frames
transmission interval.
The syntax for this command is:
show arp-tx-interval
Example:
P330-N>show arp-tx-interval
ARP tx interval is set to 5 seconds.
show autopartition
User level: user, privileged, supervisor
Use the show autopartition command to display the automatic partition.
Autopartition for the P330-ML switches will always have the value disabled.
This command is used to display the autopartition status for the other P330
switches in the stack.
The syntax for this command is:
show autopartition [module]
Example:
P330-N>show autopartition 1
Mod
--- -----------
1
102
Mode
Enable
Avaya P330 Reference Guide
Advertisement
Table of Contents
