Chapter 3
Avaya P330 Layer 3 CLI Commands
Router SRRP Context
You can only access these commands in the "Router-SRRP" context.
Type router srrp at the command prompt to enter the "Router -SRRP"
context if necessary.
poll-interval
User level: user, privileged, supervisor
Use the poll-interval command to configure the polling interval in seconds
used by SRRP.
Use the no poll-interval command to return to the default polling interval of
1 second.
The syntax for this command is:Syntax
[no] poll-interval <poll interval>
poll interval
Example:
Router-N# poll-interval 4
timeout
User level: user, privileged, supervisor
Use the timeout command to configure the timeout (in seconds) after which
SRRP declares the main router dead if it does not reply to polling.
Use the no timeout form command to return the timeout to default timeout
interval of 12 seconds.
The syntax for this command is:
[no] timeout <timeout>
timeout
Example:
Router-N# timeout 6
The timeout should be at least twice as long as the interval.
258
Poll interval (integer value, in seconds)
An integer (in seconds)
Avaya P330 Reference Guide