Event Set - Avaya P330 Reference Manual

Example:
Router-N(configure)# event log
The following message is for internal use only!!!
Z,o(9?+.ig?aDZ_Z0"Dw"ZHlJZZ,300R3333aDZt?(Z
Zt?(Z?qDZ?gXZ;z=WZYLd{z5^=}ZHt!Z^YYE
Z33D@3D3YDRTDQTD3wZ'E~MZw@T:@T:_@:_QZ~NZz'oYPZw
Z,o(9?+.ig?aDZ"Z0"D3"ZHlJZZ,300R3333aDZt?(Z
Zt?(Z?qDZ?gXZ;z=WZYLd{z5^=}ZHt!Z^YYE
Z33D@3D3YDRTDQTD3wZ'E~MZw@T:@T:_@:_QZ~NZz'oYPZw
Z,=H^zNaDZ0Z3D33ZHlJZZ,303"3333aDZ?lUl9ojoiZ Z("""?
A\Zlit?ign
Z,!AoaDZwZ0Q_D_QZHlJZZ,303w3333aDZgjKZ ZZ}>}N=Z{~/Z5{}^E}Y
Done!

event set

User level: privileged, supervisor.
This command applies to the P333R and P333R-LB only.
Use the event set command to set the level of the events.
The syntax for this command is:
event set <status>
status
Example:
Router-N(configure)# event set SVR-WARNING-ON WARNING-OFF
Router-N(configure)# event set WARNING-UP
Router-N(configure)# event set default
Avaya P330 Reference Guide
Chapter 3
Default
Possible states:
WARNING-ON | WARNING-OFF
WARNING-UP | WARNING-UP-OFF
SVR-WARNING-ON | SVR-WARNING-OFF
SVR-WARNING-UP | SVR-WARNING-UP-OFF |
Note: default status is: SVR-WARNING-UP
Avaya P330 Layer 3 CLI Commands
|
|
|
171