Ip Access-List-Dscp Operation; Ip Access-List-Dscp Trust - Avaya P330 Reference Manual

ip access-list-dscp operation

User level: privileged, supervisor.
This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip access-list-dscp operation command to set a DSCP to CoS
mapping. The system performs the mapping for only those frames than match an
ACL rule with a 'permit' action.
The syntax for this command is:
ip access-list-dscp operation <policy-list-number> <dscp>
<action>
policy-
list-
number
dscp
action
Example:
Router-N# ip access-list-dscp operation 101 0-63 permit
Router-N# ip access-list-dscp operation 101 62 fwd5

ip access-list-dscp trust

User level: privileged, supervisor.
This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip access-list-dscp trust command to decide which original
frame priority to trust for the placement of the frame in the internal priority queues.
The syntax for this command is:
ip access-list-dscp trust <policy-list-number>
{untrusted|trust-cos |trust-dscp }
policy-list-
number
Avaya P330 Reference Guide
A valid id number for a policy list currently defined for the module
(100..149)
DSCP value or range of DSCP
permit | deny | deny-and-notify | fwd0 | fwd1... fwd7:
• permit: do nothing, let the packet pass
• deny: drop the packet
• deny-and-notify: drop the packet and send an SNMP trap
• fwd0, fwd1...fwd7: set the frame COS field to 0...7
A valid id number for a policy list currently defined for the module
(100...149)
Chapter 2 Avaya P330 Layer 2 CLI Commands
29