show device-mode
User level: user, privileged, supervisor
This command does not apply to the P333R-LB which is always in "Load
Balancing" mode.
Use the show device-mode command to show the current switch operating
mode. Possible modes are Router or Switch.
The syntax for this command is:
show device-mode
Example:
Router-N> show device mode
Device mode is router
show dscp
User level: user, privileged, supervisor
This command applies to the P333R and P333R-LB only.
Use the show dscp command to display the DSCP table.
The syntax for this command is:
show dscp [<dscp>]
dscp
Avaya P330 Reference Guide
Chapter 3
dscp entry
Avaya P330 Layer 3 CLI Commands
203