Routing The Scanner Drive Cable - Canon iR2200 Service Manual

Hide thumbs Also See for iR2200:

Table of Contents

CHAPTER 3 STANDARDS AND ADJUSTMENTS

2.3 Routing the Scanner Drive Cable

Route the scanner cable as follows to the pulleys and the hook mirror base:

1) Loosen the screw on the cable fixing plate.

2) Put the ball of the cable into the hole in the drive pulley, and wind the cable firmly so

that it will not turn idly (4 runs inside, 5 runs outside); then, tape it in place. At this

time, check to make sure that the cable fixing is on the inside.

3) Engage the cable with each pulley, and temporarily fix one of its ends to the cable fixing

plate and the other to the hook on the reader frame.

4) Temporarily secure the cable fixing in place to the No. 1 mirror base. (Do not tighten the

screw fully.)

5) Fit the reader upper frame.

6) Adjust the position of the No. 1 and No. 2 mirror bases.

2000 2000 2000 2000

CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001

Table of Contents

Ir2800 Ir3300