Canon iR2200 Service Manual page 477

Transfer guide, High-voltage cord, Composite power supply PCB, DC controller PCB
(transfer faulty)
8) Is there foreign matter in the transfer guide assembly or the transfer
charging roller assembly, and is leakage noted?
YES: Remove the foreign matter.
NO:
1.
2.
Developing assembly
9) Is the developing assembly fitted securely? (Check to see if the develop-
ing block members are in firm contact with the photosensitive drum.)
NO:
Toner level detection assembly (development fault)
10)Is there toner inside the developing assembly?
NO:
•
•
Drum unit, Reader controller PCB, Main controller PCB
11)Try replacing the drum unit. Is the problem corrected/
YES: End.
NO:
•
Memo
•
•
COPYRIGHT © 2001 CANON INC.
CHAPTER 4 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Check the high-voltage cord for electrical continuity. (The resis-
tance of the transfer high-voltage cord is about 10 kΩ.)
Check the composite power supply PCB and the DC controller
PCB.
Fit the developing assembly correctly.
Check the toner sensor.
Check the connectors and the harnesses for electrical continuity.
Real the reader controller PCB and the main controller PCB.
The resistance of the high-voltage cord for primary charging is about
10 kΩ
The resistance of the high-voltage cord (white) is about 10 kΩ
The resistance of the cord for the transfer guide is about 10 kΩ
2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
4-9 T