9.4 Registration Roller Assembly
9.4.1 Removing the Registration Roller
1) Remove the front inside cover
(6 screws).
2) Remove the controller box unit.
(p. 7-19P)
3) Remove the two screws [1] each (front,
rear), and detach the front cover switch
[2] and the harness guide [3].
Take care not to damage the belt
[4].
4) Disconnect the connector [1].
5) Remove the screws [2], and detach the
terminal [3].
6) Remove the spring [4].
7) Remove the spring [1] from the front.
8) Remove the stepped screw [2], and de-
tach the developing assembly base [3].
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 5 PICK-UP/FEEDING SYSTEM
[1]
[2]
F05-904-01
F05-904-02
[3]
F05-904-03
[1]
[3]
[1]
[4]
[2]
[3]
[1]
[4]
[1]
[2]
5-51 P