Canon iR2200 Service Manual page 444

CHAPTER 3 STANDARDS AND ADJUSTMENTS
1.3.2 Adjusting the Registration for the Multifeeder Rear Front
Try the following service mode
first; if not corrected, perform
the adjustments that follow:
COPIER>FUNCTION>MF-
ADJ
1) Open the multifeeder tray.
2) Loosen the two screws [1], and move
the side guide plate unit [2] back and
forth to adjust.
Adjusting the Registration for the Deck
1.3.3
Try the following service mode
first; if not corrected, perform
the adjustments that follow:
COPIER>FUNCTION>DK-
ADJ-Y
1) Slide out the compartment.
2) Using the two screws [2], change the
position of the latch plate [1] of the
deck open solenoid (SL2D) found at the
left rear. (At this time, use the index [3]
on the latch plate as a reference.)
3) Close the compartment, and check to
make sure that the gap of the front cover
is 3 ±1 mm.
4) If the gap is not 3 ±1 mm, adjust the
front cover.
3-4 T
COPYRIGHT © 2001 CANON INC.
[1]
2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
[2]
F03-103-03
[1] [3]
F03-103-04
[1]
[2]