Attaching The Timing Belt Of The Multifeeder Tray; Checking The Image Rear Front Position; Adjusting The Registration For The Multifeeder Rear Front - Canon iR2200 Service Manual

9.2.5 Attaching the Timing Belt of the Multifeeder Tray

1) Butt the two rack plates [1] of the
multifeeder tray against both ends (area
A).
2) Move the slide volume [2] in the direc-
tion of B, and attach the timing belt [3]
to the pulley [4].

9.2.6 Checking the Image Rear Front Position

Make copies (from the Multifeeder Tray)
in Direct, and check to make sure that the
margin along the image front is 2.5 ± 1.5
mm. Otherwise, adjust the registration. (See
item 9.2.7)

9.2.7 Adjusting the Registration for the Multifeeder Rear Front

Execute 'image read start position adjust-
ment' in service mode.
COPIER>FUNCTION>MF-
ADJ-Y
Use it to adjust the image read
start position.
If correction in service mode fails, make
the following adjustments.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 5 PICK-UP/FEEDING SYSTEM
[4]
A
[1]
F05-902-08
(-) (+)
2.5 ± 1.5mm
0
2
4
6
8
10
F05-902-09
[3] [1]
B
[2]
A
5-47 P