WEG CFW-09 User Manual page 291

CHAPTER 8 - CFW-09 OPTIONS AND ACCESSORIES
292
5) At the 'Configuration' tab of the WEB page shown in figure X set, if needed,
the 'Network Parameters'. Set also the value of parameter P309.
6.1) If the inverter address on the network belongs to the reserved range
'192.168.0.X', it is possible to use the DIP-switches of the communication
board for addressing purposes. In this case, the DIP-switch represents the
binary value of the last byte in the IP address.
Example:
(MSB)
The DIP-switch is set to 00010100 (20 in decimal format).
Thus, the inverter address on the network is 192.168.0.20
6.2) If the inverter has an IP address out of the default range (192.168.0.X),
deactivate the hardware addressing by setting the DIP-switches to zero
(00000000).
6.3) If the network addressing is performed through a DHCP server, select the
box 'DHCP enabled' and set the DIP-switches to zero (00000000).
7) Click on the button 'STORE CONFIGURATION' to save the new settings.
Restart the CFW-09.
Access to the communication board
The communication board supports FTP and Telnet services. In such a way, it is
possible to upload/download files to/from the board and also access the file
system in an interactive way.
In order to use these services follow the instructions below:
- Open a MS-DOS command window.
- Type the desired service (FTP or Telnet) followed by the IP address or hostname
of the CFW-09 on the network.
- Enter with: Login: user Password: user
Examples:
Telnet session for the CFW-09 with IP address 192.168.0.4.
1 2 3 4 5 6 7 8
ON
(LSB)
.