WEG CFW-09 User Manual page 252

CHAPTER 8 - CFW-09 OPTIONS AND ACCESSORIES
Mounting Instructions:
1. Set the board configuration via S4, S5, S6 and S7 dip switches (refer to
table 8.4 a) );
2. Carefully insert terminal block XC3 (EBB) into the female connector
XC3 of the CC9 control board. Check that all pins fit in the XC3 connector;
3. Press on the EBB board (near XC3) and on the left top edge until com-
plete insertion of the connector and plastic spacer;
4. Secure the board to the metallic spacers with the screws provided;
5. Plug XC11 connector of the EBB board to the XC11 connector of the
(CC9) control board.
EBB BOARD
Figure 8.5 - EBB board layout
Figure 8.6 - EBB board installation procedure
CUTOUT
CUTOUT
EBB BOARD
CC9 BOARD
M3 x 8 Screw
1Nm Torque
253