WEG CFW-09 User Manual page 109

CHAPTER 5 - START-UP
ACTION
Power-up the inverter
Press the key. Press the
keys or until P000 is
reached
Press the key to enter the
programming mode
Use the keys and
to set the password value
Press the key to save the
programmed value and exit the
programming mode
Press the keys or
P202 is reached
Press the key to enter the
programming mode
110
In order to get a good steady-state speed regulation, the slip frequency is
calculated from the estimated load torque value (which uses the motor nameplate
data).
The following sequence is valid for Connection #1 (refer to item 3.2.7). The inver-
ter should have been already installed and powered up according to instructions
in chapter 3 and item 5.2.
LED DISPLAY
LCD DISPLAY
VFD
ready
Parameter Access
P000 = 0
Parameter Access
P000 = 0
Parameter Access
P000 = 5
Parameter Access
P000 = 5
until
Type of control
P202 = V/F 60 Hz
Type of control
P202 = V/F 60 Hz
DESCRIPTION
Inverter is ready to be operated
Enables the access to change
parameters content. With the factory
default programming [P200 = 1
(Password Active)], P000 must be set
to 5 to allow parameters changes
Enter the programming mode
Password value (factory default = 5)
Exit the programming mode
Type of Control Selection:
0 = V/F 60 Hz
1 = V/F 50 Hz
2 = V/F Adjustable
3 = Sensorless Vector
4 = Vector with Encoder
5 = VVW
Enter the programming mode