Turn Signal / Side-Stand Relay Removal And Installation; Side-Stand / Ignition Interlock System Parts Inspection - Suzuki SFV650 Service Manual

1I-8 Starting System:
Turn Signal / Side-stand Relay Removal and
Installation
Refer to "Electrical Components Location in Section 0A
(Page 0A-7)".
Removal
1) Turn the ignition switch OFF position.
2) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-4)".
3) Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.
Side-stand / Ignition Interlock System Parts
Inspection
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the component with a new
one.
Side-stand Switch
1) Turn the ignition switch OFF position.
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)".
3) Disconnect the side-stand switch coupler (1).
B944H11906007
1
I944H1190019-01
B944H11906008
1
I944H1190020-01
4) Measure the voltage between Green and Black/
White lead wires.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
ON
(Side-stand up)
OFF
(Side-stand down)
NOTE
If the tester reads 1.4 V and below when the
tester probes are not connected, replace
tester battery.
5) Connect the side-stand switch coupler.
6) Reinstall the removed parts.
Turn Signal / Side-stand Relay
The turn signal/side-stand relay is composed of the turn
signal relay, side-stand relay and diode.
G B/W
((+) probe) ((–) probe)
0.4 – 0.6 V
1.4 V and more
(Tester's battery voltage)
I944H1190021-01
I649G1190027-02