Ip Igmp Snooping Querier; Ip Igmp Snooping Query-Interval - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
2. This example shows how to restore value to accept IGMP ver-
sion 2 packets.
ZXR10(config)#no ip igmp snooping packet-manage igmpv2

ip igmp snooping querier

Use this command to set multiple proxy queriers of IGMP SNOOP-
ING. When there is no multicast router in the network, the proxy
querier sends IGMP query packets. Delete the setting with the no
form of this command.
Global configuration
ip igmp snooping querier [vlan <word>]
no ip igmp snooping querier [vlan <word>]
vlan <word>
The proxy querier is disabled by default.
This command takes no effect if the layer 3 multicast routing is
configured.
1. This example describes how to enable proxy querier.
ZXR10(config)#ip igmp snooping querier
2. This example describes how to enable proxy querier and con-
figure VLANs 10~20 as queriers.
ZXR10(config)#ip igmp snooping querier vlan 20-30

ip igmp snooping query-interval

ip igmp snooping query-response-interval
ip igmp snooping proxy
ip igmp snooping
query-interval
Use this command to configure the query interval of the proxy
querier. Restore default with the no form of this command.
Global configuration
ip igmp snooping query-interval <interval>
no ip igmp snooping query-interval
<interval>
This command takes effect only when the proxy querier is enabled.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 IGMP SNOOPING
Configures multiple querier in VLANs
Query interval (frequency for sending query
packets), in seconds, range: 30~65535,
default: 125 seconds
65