Destination-Pattern; Dial-Peer Voice - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Voice and Video Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
14 Confidential and Proprietary Information of ZTE CORPORATION

destination-pattern

Use this command to configure the phone number associated with
the dial-peer. Cancel the configuration with the no command.
Dial-up peer configuration
destination-pattern <phone-number>
no destination-pattern
<phone-number>
� The permitted phone number characters include "0~9", "#",
"*" and ".".
� The phone number length should not be longer than 30.
� This command is only applied to the dial-peer in voip or pots
type.
� The modified dial-peer configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to configure the phone number
0251111 for peer 1 in pots type.
ZXR10(config)#dial-peer voice 1 pots
ZXR10(config-pots1)#destination-pattern 0251111

dial-peer voice

Use this command to create the dial-peer or enter the specified
dial-peer configuration mode. Delete the specified dial-peer with
the no command.
Global configuration
dial-peer voice <peer-number>{pots | voip}
no dial-peer voice <peer-number>
<peer-number>
{pots | voip}
� Create up to 512 dial-peers at most.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
�
This example describes how to create dial-peer 1 in pots type.
ZXR10(config)#dial-peer voice 1 pots
ZXR10(config-pots1)#
Specifies the E.164 phone number.
Dial-up peer number, in the range of 1~65535
Dial-up peer type, pots or voip