Retrieving The Serial Number Of The Kirk Handset; Retrieving Serial Number On Kirk 3040 Handsets - Polycom KIRK 6000 Installation And Configuration Manual

KIRK Wireless Server 6000 Installation and Configuration Guide

Retrieving the Serial Number of the KIRK Handset

Retrieving Serial Number on KIRK 3040 Handsets

Note
8–12
To enable service to the handset, the serial number must be programmed into
the system database via the web based Administration Page of the KWS6000.
(For more information, refer to
The serial number (IPEI number) of each handset is found either on a label,
which is placed behind the battery, or on the packaging label.
To show the serial number on the handset display (3040 Handset/4020
Handset/4040 and 4080 Handset), press *99984*, and then press
number appears on the handset display. Press < for 5 seconds to exit the menu.
To show the serial number on the handset display (5020/5040 Handset), press
Menu, select Status and then select Firmware version. Press exit to exit the
menu.
This section describes how to retrieve the serial number on a 3040 Handset.
Press down the back cover and push it 5 mm towards the headset plug.
1
Figure 8-10 Remove Back Cover from Handset
Lift off back cover.
2
Lift the battery and read the serial number.
3
Replace battery and back cover.
4
To show the serial number on the handset display, press *99984*, and then
press ; the serial number appears on the handset display. Press < for 5
seconds to exit the menu.
"Registering KIRK Handsets" on page 13-1).
; the serial