Installing Battery On Kirk 5020 And Kirk 5040 Handsets - Polycom KIRK 6000 Installation And Configuration Manual

KIRK Wireless Server 6000 Installation and Configuration Guide

Installing Battery on KIRK 5020 and KIRK 5040 Handsets

8–6
This section describes how to install the battery on a 4020/4040/4080 Handset.
To change the battery unscrew the plate on the rear of the handset to
1
access the battery compartment. Use a normal screw driver.
Insert the screwdriver into the small crack behind the blind cover and
2
break to open the handset.
Figure 8-2 Remove Back Cover from Handset with Screw Fastener
Place the battery plug in the slot in the battery box.
3
Insert battery with the label readable.
4
Replace the back cover.
5
This section describes how to install the battery on a 5020 Handset.
To install the battery press down the back cover and slide it towards the
1
bottom of the handset.
Figure 8-3 Remove Back Cover from Handset
2 Lift off back cover.