Configuring A Kirk Wireless Server 6000 Using Dhcp; General Configuration - Polycom KIRK 6000 Installation And Configuration Manual

Configuring a KIRK Wireless Server 6000 Using DHCP

Note
Note

General Configuration

This section describes how to configure a KWS6000 using DHCP.
It is strongly recommended to configure the KWS6000 using a static IP
address.
If the KWS6000 is configured using DHCP, it is necessary to assign a
reservation for the device on the DHCP server.
For information on accessing the web based Administration Page, refer to
"Accessing the Web Based Administration Page"
This section contains information about:
• "General Configuration"
• "Wireless Server Configuration"
• "Built-In Media Resource Configuration"
• "SIP Configuration"
• "Security Configuration"
Using DHCP the device request and obtain an available IP address from a
DHCP server. The device also obtain other parameters such as the default
gateway, subnet mask, DNS server, Time server and other IP parameters from
the DHCP server.
Click Configuration, and then click General.
1
Configuring KIRK Wireless Server 6000
on page 10-13
on page 10-14
on page 10-15
on page 10-15
on page 10-15
on page 10-3.
10–13