Configuring A Kirk Base Station Using Static Ip Address - Polycom KIRK 6000 Installation And Configuration Manual

Configuring a KIRK Base Station Using Static IP Address

Figure 12-9 Adm. Page WS:Administration/Base station page
In the RPN field (Radio Part Number), type the radio part number of the
4
base station.
The radio ID can be a number between 0 and 255. See your site planner.
Note: The default value of the RPN is equal to the base station number. It
is strongly recommended not to change this value.
5 It is possible to select Auto sync if you are deploying and want to find a
sync way for the first base station.
Note: Auto sync is only to be used in a deployment situation. When
selecting Auto sync, radio part numbers in the Primary sync. (RPN) field
and Secondary sync. (RPN) field are not taken into consideration.
In the Primary sync. (RPN) field, type the radio part number of the base
6
station, you want to synchronize on. See your site planner.
In the Secondary sync. (RPN) field, type the radio part number of the
7
base station, you want to synchronize on. See your site planner.
8 Click Save.
Click Restart to enable the configuration changes.
9
To check the sync state of the base station, refer to
on page 15-26.
This section describes how to configure a base station using static IP address.
For information on accessing the web based Administration Page, refer to
"Accessing the Web Based Administration Page"
This section contains information about:
Configuring KIRK Base Station
"Sync State of Base Station"
on page 12-3.
12–9