Configuring a KIRK Wireless Server 6000 Using Static IP
Address
Note
This section describes how to configure a KWS6000 using static IP address.
The KWS6000 is pre-configured to use a static IP address. It is strongly
recommended to configure the KWS6000 using static IP address.
Figure 10-6
KWS6000 installation
For information on accessing the web based Administration Page, refer to
"Accessing the Web Based Administration Page"
This section contains information about:
•
"General Configuration"
•
"Wireless Server Configuration"
•
"Built-In Media Resource Configuration"
"SIP Configuration"
•
•
"Security Configuration"
Configuring KIRK Wireless Server 6000
on page 10-8
on page 10-9
on page 10-9
on page 10-10
on page 10-12
on page 10-3.
10–7