Recording The Installation Information; Checking Indicators; Powering The Kirk Repeater; Power Options - Polycom KIRK 6000 Installation And Configuration Manual

Recording the Installation Information

Checking Indicators

Powering the KIRK Repeater

Power Options

Programming a KIRK Repeater with the KIRK
Programming Kit

Content of the KIRK Programming Kit Repeater

Note: The external antenna used for the transmitter is to be
fixed-mounted on indoor permanent structures providing a separation
distance of at least 20 cm / 8 inches from all persons during normal
operation and must not be co-located or operating in conjunction with
any other antenna or transmitter. The maximum radiated output power is
1W e.i.r.p. For more information and technical support, please refer to
www.polycom.com.
After completing the installation of the repeaters, record the location of each
repeater.
Verify that the repeater LED indicator is continuously on, indicating that the
repeater is functional.
The power supply for the repeater is 9VDC, 300mA.
This section provides information about:
• "Content of the KIRK Programming Kit Repeater"
• "Set up of the Hardware for Repeater Programming"
• "Programming the KIRK Repeater with the ServiceTool"
The Programming Kit Repeater (Part no. 02319508) consists of:
Installing KIRK Repeater
on page 6-7
on page 6-8
on page 6-9
6–7