Installing The Kirk Codec Module - Polycom KIRK 6000 Installation And Configuration Manual

Installing the KIRK Codec Module

Note
This section describes how to install the Codec Module in a media resource.
Installation must be performed by authorized personal only and must be
performed at an approved ESD workstation.
How to install the Codec Module
Power off the media resource.
1
2 Remove the cover of the media resource carefully:
— Place the media resource face down on a desk.
— Apply sufficient pressure to the tabs located at each of the four corners
of the unit while gently lifting the cover from the chassis.
— Once separated, set the front cover aside in a safe location.
Snap the two support posts into the printed circuit board of the media
3
resource.
Carefully insert the Codec Module into the Codec Module connector and
4
the two support posts on the printed circuit board.
Figure 5-2 Installing Codec Module on Pinted Circuit Board
Replace the cover by aligning the tabs with the proper positions and
5
gently press the cover onto the chassis until the tabs lock into place.
Connect the LAN cable to the media resource.
6
Power up the media resource.
7
Installing KIRK Codec Module
5–3