Subscribe to Our Youtube Channel
Related Manuals for Polycom KIRK Wireless Server 600v3 KWS600v3
Summary of Contents for Polycom KIRK Wireless Server 600v3 KWS600v3
- Page 1 Polycom KWS600v3 Configuration Guide ® (SIP Protocol) Part No. 14168600, Ed.2 April 3, 2008...
- Page 2 Polycom, Inc. Information contained herein is subject to change without notice and does not represent commitment of any type on the part of Polycom, Inc. Polycom and Accord are registered trademarks of Polycom, Inc.
-
Page 3: Table Of Contents
Contents Chapter 1 Preface... 5 1.1 Before You Begin ... 5 1.2 Chapter Overview ... 5 1.3 Related Documentation ... 5 Chapter 2 SIP Specific Configuration ... 7 2.1 Configuring DECT Master ... 7 2.2 Configuring DECT System ... 8 2.3 Configuring Call Waiting ... - Page 4 14168600, Ed.2...
-
Page 5: Chapter 1 Preface
• that users have a working knowledge of the call handlers operation • that the call handler is installed and initialized and is working correctly • that users have a working knowledge of the KIRK Wireless Server 600v3 • that users have a working knowledge of the web based Administration Page •... - Page 6 Preface 14168600, Ed.2...
-
Page 7: Chapter 2 Sip Specific Configuration
Chapter 2 SIP Specific Configuration This section describes how to configure the KIRK Wireless Server 600v3 when using SIP Protocol. It only describes specific configuration procedures in connection with the SIP Protocol. For detailed information about installing and configuring the KWS600v3 in general, refer to the KIRK Wireless Server 600v3 Installation and Configuration Guide. -
Page 8: Configuring Dect System
SIP Specific Configuration 2.2 Configuring DECT System When configuring the KWS600v3 in a SIP environment it is necessary to enable the check boxes; Enbloc Dialing and DTMF through RTP channel. Under the Configuration menu, click DECT, and then click System. Figure 2 Adm. - Page 9 Under the Configuration menu, click DECT, and then click Features. Figure 3 Adm. Page: Configuration/DECT/Features page - SIP Protocol Select the Enable check box to enable the Call Waiting feature. Click OK. Click reset required. A window appear. Click OK. The Call Waiting feature is now enabled in the system.
- Page 10 SIP Specific Configuration 14168600, Ed.2...
Need help?
Do you have a question about the KIRK Wireless Server 600v3 KWS600v3 and is the answer not in the manual?
Questions and answers