Polycom KIRK 6000 Installation And Configuration Manual page 130

KIRK Wireless Server 6000 Installation and Configuration Guide
Note
Note
13–4
• Auto Login A should only be used in separate systems without overlaps.
If a handset looses signal from the system (the display showing Out of
Range), then after 20 seconds the handset will start searching for an
alternative system available from the Login list and automatically change
to this system.
Note: Using Auto Login A any call will be dropped when changing to an
alternative system.
This section provides information about:
• "Subscribing Handsets"
• "Subscribing a Handset to Different Systems"
Using Auto Login A any call will be dropped when changing to an
alternative system.Subscription of handsets requires the use of each
registered handset.
To make subscriptions, the system must allow subscriptions to be made
(refer to "Wireless Server Configuration"
also require an Authentication Code (AC). If more than one system
currently permits subscription, you will need to know the ID of the system
(ARI code) to which you wish to subscribe. Authentication Codes and
system ID's (ARI codes) will be provided by the system administrator.
Before subscribing handsets you need to ensure:
• that handset battery has been charged
Low battery could cause subscription problems.
• that the handsets have been registered to the system
Handsets" on page 13-1).
on page 13-5
on page 13-5
on page 10-9). Some systems
("Charging Battery" on page 8-9).
("Registering KIRK