Configuring Kirk Media Resources; Powering Up The Kirk Media Resource - Polycom KIRK 6000 Installation And Configuration Manual

Configuring KIRK Media Resources

Note

Powering up the KIRK Media Resource

This section provides you with information on how to power up the media
resource and connect the unit to a computer. It also provides information on
how to configure a media resource through the web based Administration
Page using either DHCP or static IP address.
The media resource is pre-configured to use DHCP. It is recommended to
configure the media resource using DHCP.
This section includes information about:
• "Powering up the KIRK Media Resource"
• "Connecting a Computer to the KIRK Media Resource"
"Accessing the Web Based Administration Page"
•
• "Configuring a KIRK Media Resource Using DHCP"
• "Configuring a KIRK Media Resource Using Static IP Address"
page 11-7
"Checking Indicators"
•
• "Making a Back-Up of the Configuration File"
After installing the media resources you need to power up the unit using:
Local Power Supply
•
Power options for the KWS6000 is 48VDC, 1 W maximum when using
local power supply.
on page 11-1
on page 11-7
11
on page 11-2
on page 11-3
on page 11-6
on
on page 11-8
11–1