Powering Up The Kirk Base Station - Polycom KIRK 6000 Installation And Configuration Manual

Configuring KIRK Base Station
Note

Powering up the KIRK Base Station

This section provides you with information on how to connect the base station
to a KWS6000 and how to configure the base station through the web based
Administration Page using either DHCP or static IP address.
The base station is pre-configured to use DHCP. It is strongly
recommended to configure the base station using DHCP.
This section includes information about:
• "Powering up the KIRK Base Station"
• "Connecting a Computer to the KIRK Base Station"
• "Accessing the Web Based Administration Page"
• "Configuring a KIRK Base Station Using DHCP"
• "Configuring a KIRK Base Station Using Static IP Address"
• "Checking Indicators"
• "Making a Back-Up of the Configuration File"
After installing the base station you need to power it up. The base station uses:
• Power over Ethernet (PoE 802.3af).
Maximum power supply consumption is 3.0W (IEEE 802.3af class 1
•
device).
Use a standard PoE adapter or a PoE-enabled port on a switch adhering to PoE
802.3af when connecting the base station to a PoE power source.
on page 12-1
on page 12-11
12
on page 12-2
on page 12-3
on page 12-6
on page 12-9
on page 12-11
12–1