Kirk Base Station - Reset Button; Resetting The Kirk Base Station Hardware; Installing The Kirk Base Station; Wall Mounted (Vertical) Installation Rf Coverage - Polycom KIRK 6000 Installation And Configuration Manual

KIRK Base Station - Reset Button

Installing the KIRK Base Station

Note

Wall Mounted (Vertical) Installation RF Coverage

Caution:
It is possible to restart or reset the base station by pressing the Reset button on
the faceplate of the base station. For description of the faceplate, refer to
"Faceplate" on page 6-4.

Resetting the KIRK Base Station Hardware

This section contains a description of the different actions that take place when
pressing the Reset button.
Table 6-3 Reset Button Description
Press button
Short press (2 to 5 sec.)
Long press (5 to 9 sec.) until
front LED flashes red, then
release button
The base station is suitable for mounting indoors on a wall.
Before beginning the installation, determine the position of the base station
for best coverage. The coverage depends on the construction of the
building, architecture, and the choice of building materials. Refer to

"Environmental Requirements"

environmental requirements for base stations.
For best RF coverage, the base station must be mounted vertically on walls.
The antennas must always be kept perpendicular to the floor.
The base station must not be installed at any angle other than vertical. If the
base station is placed upside-down, the coverage area of the base station is
decreased by 40 - 50% and it might not transmit or receive effectively.
Action
System restarts when button is
released.
Resets the system to factory default
settings (original IP settings and
empty user data base) and restarts
the system.
Firmware version is not affected.
for more information about
on page 2-8
Installing KIRK Base Station
6–5