Restarting The Kirk Wireless Server 6000 - Polycom KIRK 6000 Installation And Configuration Manual

KIRK Wireless Server 6000 Installation and Configuration Guide

Restarting the KIRK Wireless Server 6000

Note
15–14
Figure 15-20 Adm. Page: Firmware Update Progress Bar
Optionally, you can block new calls during a firmware update by clicking
5
Administration, and then Wireless Server.
Figure 15-21 Adm. Page WS: Administration/WS page
Under Service Status click Block.
Click Reboot to update the KWS6000 firmware.
6
If you have blocked new calls during a firmware update, enable new calls
7
again by clicking Administration, then Wireless Server and then clicking
Allow.
Some configuration changes requires a restart in order to take effect. A reset
restarts the KWS6000 software.
Ensure that you have opened the Administration Page of the KWS6000.
You must restart the system after the following procedures:
• configuring
uploading configuration data
•
• uploading firmware