Kirk Base Station; Changing System User Name And Password - Polycom KIRK 6000 Installation And Configuration Manual

KIRK Base Station

Changing System User Name and Password

Note
This section includes information about:
• "Changing System User Name and Password"
• "Reading System Information"
• "Reading Statistics"
• "Sync State of Base Station"
• "Updating the KIRK Base Station Firmware"
Ensure that you have opened the Administration Page of the base station.
From the Administration Page it is possible to change the user name and
password for the system.
Click Configuration, and then click Security.
1
Figure 15-36 Adm. Page Base Station: Configuration/Security page
In the Current password field, type the current password.
2
In the New user name field, type a user name.
3
4 In the New password field, type a new password
In the New password again field, type the new password again to
5
confirm it.
Click Save to change the password.
6
on page 15-24
on page 15-26
on page 15-26
System Management
on page 15-23
on page 15-28
15–23