Configuring A Kirk Media Resource Using Static Ip Address; General Configuration; Media Resource Configuration; Checking Indicators - Polycom KIRK 6000 Installation And Configuration Manual

Configuring a KIRK Media Resource Using Static IP
Address

General Configuration

Media Resource Configuration

Checking Indicators

Note
This section describes how to configure a media resource using static IP
address.
This section contains information about:
"General Configuration"
•
• "Media Resource Configuration"
On the Configuration/General page you define IP, DNS and NTP settings for
the media resource.
Refer to "General Configuration"
On the Configuration/Media Resource page you configure the media
resource.
Click Configuration, and then click Media Resource.
1
Figure 11-6 Adm. Page Media Resource: Config./Media Resource page
In the Host field, type the address of the wireless server.
2
Click Save.
3
• Verify that the media resource LED indicator is continuously on,
indicating that the media resource is functional.
The LED will not be on before the base stations are configured.
Configuring KIRK Media Resources
on page 11-7
on page 11-7
on page 10-8 for a description.
11–7