Speed; Multicast-Data-Rate - HP ProCurve 420 Management And Configuration Manual

Hide thumbs Also See for ProCurve 420:
Table of Contents

Advertisement

Command Line Reference
Interface Commands
6-70

speed

This command configures the maximum data rate at which a station can
connect to the access point.
Syntax
speed <speed>
speed - Maximum access speed allowed for wireless clients.
(Options: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps)
Default Setting
54 Mbps
Command Mode
Interface Configuration (Wireless)
Command Usage
The access point supports automatic rate adjustment, which dynamically
changes the data rate to maintain optimum connectivity with clients. You
can set a maximum data rate for all clients, however individual clients will
fall back to lower rates depending on their connection conditions. Clients
farther away from the access point will use a lower data rate than clients
close to the access point.
Example
HP420(if-wireless g)#speed 6
HP420(if-wireless g)#

multicast-data-rate

This command configures the maximum data rate at which the access point
transmits multicast and broadcast traffic.
Syntax
multicast-data-rate <speed>
speed - Maximum rate allowed for multicast data. (Options: 1, 2, 5.5,
11 Mbps for b-only and b+g modes; 6, 12, 24 Mbps for g-only mode)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 420 and is the answer not in the manual?

Table of Contents