Table of Contents
Advertisement
Command Line Interface (CLI)
Set the Distance Between APs (802.11b Only)
[Device-Name]>set wif <index> distaps <large, medium, small, minicell, microcell>
[Device-Name]>reboot 0
NOTE
The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in
which an AP is set up and clients are tested throughout the area to determine signal strength and coverage,
and local limits such as physical interference are investigated. From these measurements the appropriate cell
size and density is determined, and the optimum distance between APs is calculated to suit your particular
business requirements.
Set the Multicast Rate (802.11b Only)
[Device-Name]>set wif <index> multrate <1,2,5.5,11
NOTE
The Distance Between APs must be set before the Multicast Rate.
Set Ethernet Speed and Transmission Mode
[Device-Name]>set etherspeed <value (see below)>
[Device-Name]>reboot 0
Ethernet Speed and Transmission Mode
10 Mbits/sec - half duplex
10 Mbits/sec - full duplex
10 Mbits/sec - auto duplex
100 Mbits/sec - half duplex
100 Mbits/sec - full duplex
Auto Speed - half duplex
Auto Speed - auto duplex
Set Interface Management Services
Edit Management IP Access Table
[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Configure Management Ports
[Device-Name]>set snmpifbitmask <(see below)>
[Device-Name]>set httpifbitmask <(see below)>
[Device-Name]>set telifbitmask <(see below)>
Choose from the following values:
Interface bitmask
0 or 2 = disable (all interfaces)
1 or 3 = Ethernet only
4 or 6 = Wireless A only
8 or 10 = Wireless B only
12 = Wireless A and Wireless B
13 or 15 = all interfaces
Value
10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default)
Description
All management channels disabled
Ethernet only enabled
Wireless A only enabled
Wireless B only enabled
Wireless A and Wireless B enabled
All management channels enabled
>
(Mbits/sec)
C-19
Advertisement
Table of Contents
