Snmpv3 Targets - HP ProCurve 420 Management And Configuration Manual

Command Line Reference
SNMP Commands
6-34
Example
HP420(config)#snmpv3 user
User Name<1-32>
Group Name<1-32>
Authtype(md5,<cr>none):md5
Passphrase<8-32>:a good secret
Privacy(des,<cr>none) :des
Passphrase<8-32>:a very good secret
HP420(config)#

snmpv3 targets

This command configures SNMP v3 notification targets. Use the no form to
delete an SNMP v3 target.
Syntax
snmpv3 targets <target-id> <ip-addr> <sec-name> [version {3}] [udp-port {port-
number}] [notification-type {TRAP}]
no snmpv3 targets <target-id>
• target-id - A user-defined name that identifies a receiver of SNMP
notifications. (Maximum length: 32 characters)
ip-addr - Specifies the IP address of the management station to
•
receive notifications.
sec-name - The defined SNMP v3 user name that is to receive
•
notifications.
• version - The SNMP version of notifications. Currently only version
3 is supported in this command.
udp-port - The UDP port that is used on the receiving management
•
station for notifications.
notification-type - The type of notification that is sent. Currently only
•
TRAP is supported.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The access point supports up to 10 SNMP v3 target IDs.
:chris
:RWPriv