Configuring Tcp/Ip Settings - HP ProCurve 420 Management And Configuration Manual

Figure 4-6. Radio Channel Selection

Configuring TCP/IP Settings

You can use the web browser interface to manage the access point only if it
already has an IP address that is reachable through your network. You can set
an initial IP address for the access point by using the CLI interface. After you
have network access to the access point, you can then use the web browser
interface to modify the initial IP configuration.
Click the Configuration tab, and then click the
1.
2. Select either Obtain the IP Address from the DHCP Server or Use the Static IP
Address below.
3. If you select to use a static IP address, you must manually enter the IP
address and subnet mask.
4. If a management station exists on another network segment, enter the IP
address of a gateway that can route traffic between these segments.
Using the HP Web Browser Interface
Tasks for Your First HP Web Browser Interface Session
[IP Configuration] button.
4-13