Cli: Configuring Snmp V3 Trap Targets And Filters - HP ProCurve 420 Management And Configuration Manual

Figure 5-9. Adding SNMP Trap Filter Objects

CLI: Configuring SNMP v3 Trap Targets and Filters

CLI Commands Used in This Section
Command Syntax
[no] snmpv3 filter <filter-id> <include | exclude> <subtree>
[no] snmpv3 filter-assignments <target-id> <filter-id>
[no] snmpv3 targets <target-id> <ip-addr> <sec-name> [version page 6-34
{3}] [udp-port {port-number}] [notification-type {TRAP}]
show snmpv3
Access Point Configuration
Configuring SNMP
CLI Reference Page
page 6-35
page 6-36
page 6-37
5-25