HP ProCurve 420 Management And Configuration Manual page 66

Access Point Configuration
Modifying System Information
5-8
----------------Antenna-----------------------------------
Antenna mode
Antenna gain attenuation
Low channe
Mid channe
High chann
===========================================================
HP420(if-wireless g)#
To display the configured system name, use the show system command, as
shown in the following example.
HP420#show system
System Information
============================================================
Serial Number
System Up time
System Name
System Location
System Contact
System Country Code : NA - North America
MAC Address
IP Address
Subnet Mask
Default Gateway
VLAN State
Native VLAN ID
IAPP State
DHCP Client
HTTP Server
HTTP Server Port
Slot Status
Software Version
===========================================================
HP420#
: Single
l : 100%
l : 100%
el : 100%
: A252014354
: 0 days, 1 hours, 28 minutes, 9 seconds
: AP420
:
: Contact
: 00-30-F1-81-83-12
: 192.168.1.1
: 255.255.255.0
: 0.0.0.0
: DISABLED
: 1
: ENABLED
: ENABLED
: ENABLED
: 80
: Dual band(b/g)
: v2.0.38.0B032