Country - HP ProCurve 420 Management And Configuration Manual

Command Function
System Clock Sets the system clock via an NTP/SNTP server
sntp-server ip Specifies one or more time servers
sntp-server Accepts time from the specified time servers
enable
sntp-server Manually sets the system date and time
date-time
sntp-server Sets the start and end dates for daylight savings time
daylight-saving
sntp-server Sets the time zone for the access point's internal clock GC
timezone
show sntp Shows current SNTP configuration settings
System Status Displays system configuration and version information
show system Displays system information
show version Displays version information for the system

country

This command configures the access point's Country Code, which identifies
the country of operation and sets the correct authorized radio channels.
This command is available only if you are using the worldwide product,
J8131A.
Syntax
country <country_code>
country_code - A two character code that identifies the country of
operation. See Table 6-1 on page 6-10 for a full list of the available
codes.
Command Line Reference
System Management Commands
Mode
GC
GC
GC
GC
Exec
Exec
Exec
Page
6-19
6-20
6-20
6-21
6-22
6-23
6-23
6-24
6-9